Oscillators

 

Image

Mix:      proportion between level of signals from oscillator 1 and oscillator 2

Phase/Detune:      sets phase or detune of oscillator 2

1st half – phase shift amount

2nd half – detune (0..12 semitones)

Chord:      monophonic/paraphinic mode

In paraphonic mode 4 duplicate oscillators sections, controlled by up to 4 keys, share the same filter and amp section

Waveform:      Oscillator 1 waveshape

Smooth transition – down-saw, triangle, up-saw, square pulse width

Glide:      sets legato time (0 = off)

Auto:      glide is active only on overlapping notes

Mod:      Oscillator modulation amount by LFO modulator

Modulation targets (switch):

Wave1 – Oscillator 1 waveshape

Middle position – Phase/Detune

Pitch – pitch of both oscillators

Oscillator 2

Sync – Oscillator2 is hard-synchronized to oscillator 1

Waveform – oscillator 2 wave, morphable noise at maximum value

Octave – oscillator 2 octave

Retrig – oscillators phase will be restarted on each note

Filters

 

High-pass filter

Image

Spice:      simulates faulty components

Frequency:      filter cutoff frequency

Resonance:      filter resonance

Track:      keyboard tracking (0, 50, 100%)

 

Low-pass filter

Image

Model:

Brute – Steiner-Parker filter (12dB/oct)
Nonlinear resonance

Primal – highly non-linear transistor ladder (24dB/oct)
Up and down saw waves sound differently

Rogue – transistor ladder (24dB/oct)

Ronin – diode ladder (s4dB/oct)

Drive:      amount of filter internal distortion

Frequency:      filter cutoff frequency

Resonance:      filter resonance

Filter cutoff modulation by:

MOD:      LFO

ENV:      Envelope

Osc2:      Oscillator 2 (beware!)

Track:      keyboard tracking (0, 50, 100%)

 

Modulators

Image

 

ADSR envelope generator

Attack:      attack time

Decay:      decay time

Sustain:      sustain level

Release:      release time

Three state switch:

Retrig – each note event (including overlapping) retriggers envelope

Gate – overlapping notes will not retrigger envelope

LFO – envelope will repeat at LFO rate

Velocity:      key velocity

Filter

+

Amp

 

Multi-mode LFO

Rate:      modulation rate

Mode:      Sine, square, sample&hold, noise, decay envelope (1 shot), sinewave that follows oscillators frequency

Switch:

Key – each keypress will restart modulator

Free – LFO is freerunning

Tempo – modulation cycle is synchronized to host tempo

Modulation wheel (MIDI) modulation target:

Off

Hpf – High-pass filter cutoff frequency

Lpf – Low-pass filter cutoff frequency

Mod – LFO modulation amount (affects all LFO targets)

Amplifier

Image

Drive:      Assymetrical diode cliper distortion amount

Level:      Amplifier level

Mod:      LFO amp level modulation

Amplifier level is controlled by:

R – partial envelope with attack = 0 and sustain = 1 (full)

AR - partial envelope with sustain = 1

ADSR – ADSR envelope

 

Image