Auria Pro Channel & Effects Routing Questions

Tones4Christ

Guys, in AP pro mixer channel where one adds the audio effects, what’s the signal flow top to bottom or bottom to top?

Question2: how can i tell if an effect is post or pre in the channel strip.

Question 3: If im sending via Aux to another channel hosting an effects like delay or reverb is the Aux being sent post or pre?

Thanks guys just trying to create a good effects chain for my electric guitar with the awesome Nembrini effects.

Gravitas

@Tones4Christ said:
Guys, in AP pro mixer channel where one adds the audio effects, what’s the signal flow top to bottom or bottom to top?

Top to bottom

Question2: how can i tell if an effect is post or pre in the channel strip.

The Aux's are either pre or post not the effects in the channel strip.

Effects in the channel strip are always post.

Question 3: If im sending via Aux to another channel hosting an effects like delay or reverb is the Aux being sent post or pre?

You can choose if an Aux send is either pre or post in the settings.

Thanks guys just trying to create a good effects chain for my electric guitar with the awesome Nembrini effects.

Yeah, I know the feeling.

I've been doing the same except in AUM
which I can then route directly into Auria Pro.

mjcouche

This was after some tweaking. For context, I use a Gibson LP into Shure MVi. Ownhammer IR GNR or Celestion V30.

https://www.dropbox.com/s/2gbsb217cowbuqs/Guitar Chain 2.zip?dl=0

Tones4Christ

Thanks so much guys! Been using AUM so long i forgot how to route in AP.

@mjcouche is this an Auria preset?

@Gravitas said:

@Tones4Christ said:
Guys, in AP pro mixer channel where one adds the audio effects, what’s the signal flow top to bottom or bottom to top?

Top to bottom

Question2: how can i tell if an effect is post or pre in the channel strip.

The Aux's are either pre or post not the effects in the channel strip.

Effects in the channel strip are always post.

Question 3: If im sending via Aux to another channel hosting an effects like delay or reverb is the Aux being sent post or pre?

You can choose if an Aux send is either pre or post in the settings.

Thanks guys just trying to create a good effects chain for my electric guitar with the awesome Nembrini effects.

Yeah, I know the feeling.

I've been doing the same except in AUM
which I can then route directly into Auria Pro.

@mjcouche said:
This was after some tweaking. For context, I use a Gibson LP into Shure MVi. Ownhammer IR GNR or Celestion V30.

https://www.dropbox.com/s/2gbsb217cowbuqs/Guitar Chain 2.zip?dl=0

Tones4Christ

What im trying to replicate my floor pedals flow which goes into a fender blues deluxe amp.

Current set up is like this:

Jeckyl & Hyde OD into Joyo American Sound pedal to Volume pedal > Modulation effects > to amp.

But was wondering how to set something like this in Auria.

mjcouche

@Tones4Christ this is an AUM preset

Tones4Christ

Awesome! Will check it out!